DOI: 10.5937/jaes11-3723
This is an open access article distributed under the CC BY-NC-ND 4.0 terms and conditions.
Volume 11 article 254 pages: 99-105
This paper analyses the distribution of stress through steam line of medium superheated steam with the special emphasis on the critical location, the bend, in order to estimate the remaining lifecycle of a steam line. MoreoveR it presents the theoretical basis of the beam superelement with 2D cross-section segment which was used for analysis in PAK software.The obtained results of stress analysis and estimated reliability of the construction after 200.000 hours of exploitation are shown.
The part of this research is supported by Ministry
of Education, Science and Technological Development, Republic of Serbia,
Grants TR32036 - Software development for solving coupled multiphysics
problems.
ALGOR PipePak, Pipe
Stress Analysis and Design System for PC Workstations, ALGOR INC. (1993),
Pittsburgh
American national
standard "Power piping”, Asme code for pressure piping, ASME/ANSI B31.1,
(2001), American society of Mechanical Engineering, USA
Dr Maksimovi S., Blazic
M, Maksimovic, M. (2010): Design of constructions with respects to fatigue and
fracture mechanics, Journal of Applied Engineering Science (Istrazivanja
i projek- tovanja za privredu), Vol. 8, No. 4, pp. 181-188
FEMAP User Guide,
(2002), Unigraphic Solution Inc, Exton, USA
Jakovljevic A.,
(2004): Impact of damage and stress state of material to the remaining life
cycle of high-pressure steam line (in Serbian), Beograd, master thesis
Kojic M., Slavkovic
R., Zivkovic M., Grujovic N., (2003) User Manual for PAK-finite element
program for linear and nonlinear structural analysis and heat transfer,
Kragujevac, Faculty for Mechanical Engineering, University of Kragujevac
Kojic M., Slavkovic R., Zivkovic
M., Grujovic N., (1998): Finite element method I
(in Serbian), Kragujevac, Faculty for Mechanical Engineering, University of
Kragujevac
Pantelis N. Botsaris, E. I. Konstantinidis, D. Pitsa, (2012): Systemic
assessment and analysis of factors affect the reliability of wind, Journal of
Applied Engineering Science (Istrazivanja i projektovanja za privredu), Vol. 10, No. 2, pp. 85-92