DOI: 10.5937/jaes16-16442
This is an open access article distributed under the CC BY-NC-ND 4.0 terms and conditions.
Volume 16 article 528 pages: 263 - 266
The article is devoted to the improvement of the quality of tree-trunks delimbing by means of time-effective bringing the delimbing knife into an operating position before its contact with the branches. The set goal was achieved by bringing the delimbing knife into the operational mode, parallel to the direction of the tree-trunk feed motion, following the load shift of the pusher beyond the cutting edge. This type of load emerges when the branches press upon the pusher. After the stress is finished both mechanisms return to their original position. The described method and the construction of the mechanism provides placement of the delimbing knife in the operational position, thus enhancing the delimbing quality.
The research was conducted with the financial support from the ООО Martreyd, (a limited liability company under the laws of Russian Federation) in the frames of the scientific and research project №06.522/18.
1. A.V. Demchuk. (2012)
Modernization of the technological equipment of harvester for improving the
efficiency of delivery of logs. Engineering Bulletin of Don. Volume: 20. № 2:
542-546.
2. F.V.Poharnikov, Yudina N.Y., Bulanov A.S.,. Ladentsov P.G. (2012) Analysis
of the state of the technical equipment of the forest process industry.
Lesotechnic journal, № 2:100-105.
3. P.M.Mazurkin. (1990) Search design of forestry equipment: Study Guide -
Saransk: publishing house of the University of Saratov: 304.
4. P.V. Budnik. (2012) Functional-technological analysis of harvesteral head.
Science and business: ways of development. 9 (15): 036-038.
5. V.S. Syunyov, A.A Seliverstov. (2005) Working bodies of harvesters.:
designing and calculation. Monograph/Petrozavodsk: Feder. Education Agency, Gos.
educated. institution of higher education. prof. education Petrozav. state.
un-t: 204.